Here is a timelapse video with Wiktor building the shelves in different sizes. At the end of the video you can see set of 3 bookshelves in different sizes. The shelves look great.
Look for a special 6 faces key and place it in your electric screwdriver.
If you don’t have one please borrow from neighbor as it is very difficult to hold this key in bare hands
In case of emergency (lost special key or screws are not responding to special key due to lock in material) this key can be replaced with h6 bit or t25 bit; best as a hex key / imbus key / Allen wrench).
Place something soft on the floor and place on it the bottom part of the bookshelf. The bottom part is the one that has carved grooves for the backs but not all the way out.
You can also build the Bookshelf placed on the back.
Photo: grooves in bottom part are aligned with the grooves on the side.
- If you are assembling the big body parts, please have in mind that there are higher shelves on the top. The long grooves for the backs should be placed on the same side that they are marked on the bottom part of the bookshelf.
- Mount the bookshelf top.
- Insert shelves but not all the way back. We just need shelves to push the sides apart so there will be more room for inserting backs.
- Insert backs from the top using specially carved grooves. You can order them in any way you want but please remember that the bigger backs should be slide as the last.
- Push the shelves all the way back.